QHYCCD

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DaveS

Pages: [1]
1
Astronomy equipment Discussion board / Re: Gain / Offset window in Maxim
« on: February 26, 2021, 08:10:02 AM »
Thanks for the link. After persuading Windows that the file was not malicious I managed to install it.

That Gain / Offset widow is still there. but now the Offset can be adjusted away from the nonsensical value of -1

2
Astronomy equipment Discussion board / Re: Gain / Offset window in Maxim
« on: February 26, 2021, 06:45:17 AM »
Many thanks.

Having to work around as Windows didn't like the file.

3
Astronomy equipment Discussion board / Re: Gain / Offset window in Maxim
« on: February 25, 2021, 11:38:51 AM »
This is the setup window I see, noting the firmware / driver versions.

4
Astronomy equipment Discussion board / Gain / Offset window in Maxim
« on: February 25, 2021, 10:48:41 AM »
First post and a question. Sorry.

I have a QHY268M that I'm running under Windows 10 and Maxim 6.24 using the latest (?) software version. After going through the Maxim camera set up sequence I get this ASCOM window.

The Gain value follows the value set in the QHY camera setup window, but the Offset value is greyed out at a nonsensical -1
Has anyone else seen this? If so what can be done to either allow Offset to be adjusted in the window or to get rid of it?

Pages: [1]