Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - DaveS

Pages: [1]
Astronomy equipment Discussion board / Gain / Offset window in Maxim
« on: February 25, 2021, 10:48:41 AM »
First post and a question. Sorry.

I have a QHY268M that I'm running under Windows 10 and Maxim 6.24 using the latest (?) software version. After going through the Maxim camera set up sequence I get this ASCOM window.

The Gain value follows the value set in the QHY camera setup window, but the Offset value is greyed out at a nonsensical -1
Has anyone else seen this? If so what can be done to either allow Offset to be adjusted in the window or to get rid of it?

Pages: [1]